Overview
The iFlight GM110-10 is a brushless direct-drive gimbal motor designed for camera stabilization systems. It is intended for SLR aerial setups and Z-axis DIY parts, using BLDC-based gimbal stabilization principles similar to hobby-servo gimbal systems.
Key Features
- Sealed case to help prevent contamination from dust and dirt
- Hollow shaft design for slipring integration
- 36N/42P configuration for higher torque
Specifications
| Model | GM110-10 |
| Motor Out Diameter | Dia. 1100.05 mm |
| Configuration | 36N/42P |
| Motor Height | 260.2 mm (Included with Encoder housing) |
| Hollow Shaft (OD) | Dia. 25 -0.008/-0.012 mm |
| Hollow Shaft (ID) | Dia. 22 +0.05/+0.1 mm |
| Wire Length | 6103 mm |
| Cable AWG | #24 |
| Motor Weight | 5321 g |
| Wire plug | 2.5 mm dupont connector |
| No-load current | 0.160.1 A |
| No-load volts | 20 V |
| No-load Rpm | 292~323 RPM |
| Load current | 2 A |
| Load volts | 20 V |
| Load torque (g.cm) | 9000-15000 |
| Motor internal resistance | 4.16 ohm 5% (Resistance varies with temperature) |
| High voltage test | DC500V 1mA @ 2 sec |
| Rotor housing runout | <=0.1 mm |
| Steering (axle extension) | clockwise |
| High temperature test | Keep at 60C for 100 hours, and the motor can work normally after 24 hours at room temperature |
| Low temperature test | Keep at -20C for 100 hours, and the motor can work normally after 24 hours at room temperature |
| Maximum power | <=80 W |
| Working current | 4-6S |
| Working temperature | -20~60C; 10~90%RH |
For compatibility questions (slipring fitment, wiring/connector matching, or gimbal controller setup), contact [email protected] or visit https://rcdrone.top/.
What’s Included
- 1 x GM110-10 brushless gimbal motor
Reviews
There are no reviews yet.