RC ERA UH-1 C032 Receiver Set Flight Controller/Receiver Board (OEM)

Bring your C032 back to the air with this OEM receiver set (flight controller/receiver board). Matched firmware and connectors deliver reliable signal link, smooth stabilization, and clean plug-and-play replacement.

Key Features

• OEM 2.4GHz receiver/flight controller tuned for the C032 system

• Restores hover stability and crisp, responsive control inputs

• Pre-labeled ports for servos, motors, ESC, and optional optical-flow/laser module

• Compact, lightweight PCB preserves CG and flight time

• Version-matched stabilization logic for the C032 platform

Compatibility

Purpose-built for the C032 and fully compatible with:
RC ERA UH-1 Huey 6CH RC Helicopter with Smart Positioning & 3D Stunt Flight

Not universaluse with the C032 series only.

Whats in the Pack

• Receiver/Flight Controller Board 1

• Wiring harness / mounting pad / screws (included only if shown in product photos)

Binding & Setup Tips

• Remove main blades or work in a safe area before radio setup

• Power the model with trims centered, then follow your radios bind procedure

• If your board has a bind button/pads, press/short per the boards marking

• Place the model level during first power-up to aid stabilization calibration

• Perform a low-hover test and fine-trim if needed

Installation Notes

• Power off & disconnect the battery before any work

• Note plug orientation and polarity; route wires clear of gears and rotor

• Keep the antenna straight and exposed, away from carbon/metal shielding

• If using the optical-flow/laser module, keep the sensor windows clean and connect to the designated ports

More C032 Spare Parts

Need ESC, motors, blades, gears, skids, or linkages?
Explore the full range: C032 Spare Parts Collection