RC ERA C123 Receiver Board (Flight Controller) Genuine Replacement

Restore factory flight performance on your RC ERA C123 6CH Brushless RC Helicopter with this OEM receiver/flight-controller board. It integrates the 2.4 GHz receiver, gyro stabilization, and ports for the C123s brushless ESC, servos, tail system and optical-flow module, delivering the same smooth, predictable handling as the stock unit.

Highlights

• Direct fit: Mounting pattern, connectors and wire lengths match the original C123 board.
• All-in-one design: Built-in 2.4 GHz receiver, flight controller, gyro and power distribution.
• Stability you trust: Pre-tuned for the C123 airframe, three speed/mode support.
• Plug-and-play: Labeled sockets for motor/ESC, servos, tail motor, optical-flow and battery.
• Clean install: Lightweight PCB keeps CG and wiring neat for reliable performance.

Compatibility

Designed specifically for the RC ERA C123 (Mode 1 or Mode 2 transmitter). If adapting to other models, confirm connector types, channel mapping, ESC/tail outputs and sensor requirements.

Whats in the Box

• Receiver/flight-controller board for RC ERA C123 (no screws; reuse original hardware)

Installation Tips

• Disconnect the flight battery before servicing. Observe polarity on every plug.
• Note each connector location on the old board (photos help) and transfer one-by-one.
• Install with the orientation arrow/label facing forward; keep the board level.
• Avoid overtightening; use foam tape where supplied to reduce vibration.

Binding & Setup

• After replacement, re-bind to your transmitter (follow your radios bind steps). Indicators on the board will confirm a successful link.
• Power up on a level surface and keep the heli still for gyro initialization.
• If equipped, ensure the optical-flow sensor window is clean and unobstructed.

Note: This is a factory-spec board. Third-party firmware flashing is not supported.

Care & Safety

• Keep connectors seated fully; check after hard landings.
• Do not expose the PCB to moisture; store and transport in an antistatic bag.
• If you see abnormal heat or persistent drift, land and re-inspect wiring and mounting.

More C123 Spare Parts

Need batteries, landing gear, motors, rotor head and more? Browse all accessories here: RC ERA C123 Spare Parts Collection.